User Manual
Table Of Contents
- Warnhinweise
- Introduction
- Asssembly
- Assemble the base
- Adjust the height of the casters
- Attach the column to the base
- Assemble the TV mount
- Attach the support plate to the column
- Move the support plate to the lowest position
- Attach the adapter brackets to a flush mounting surface
- Attach the adapter brackets to a recessed mounting surface
- Attach the TV to the column
- Counterbalance the weight of the TV
- Attach the plastic cover
- Attach the cable clips
- Install the multimedia shelf
- Attach the camera shelf
- Attach the wrench
- Adjusting the STNDMTV70
- Technical support
- Warranty information
Instruction manual
11
Asssembly
Warning! Assembling this product requires multiple people. DO NOT attempt to
assemble this product and install equipment without assistance.
Assemble the base
1. Insert the base into the left leg, aligning the holes in the base with the holes in the
left leg.
2. Insert two M6x16 mm screws through the left leg and into the base.
3. Use the hex key to tighten the M6x16 mm screws.
4. Repeat steps 1 to 3 to attach the right leg. (gure 1)
gure 1
Right leg
Left leg
Base
M6x16 mm screw
Hex key