User Manual

7
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Firmware Updates
To update the Firmware or perform a Factory Reset select
the Settings tab then the System tab. Select Update for a
Firmware Update and Reset for a Factory Reset.
Network Information
To check the MAC Address, and to change the IP Mode, IP
Address, Subnet Mask, Default Gateway, and DNS Server
Address, select the Network tab and make the appropriate
changes.
Note: When the IP Mode and/or IP Address are reset the
Splitter will automatically disconnect. The Splitter must be
reconnected by selecting the ID Name of the Splitter.
EDID and HDCP Settings
To adjust the EDID and/or HDCP Settings, or to view the sync
status of the HDMI Source Device, select the Input tab and
select the appropriate settings under the dropdown menus.
Select Save to save the new settings. Alternatively, click Save to
All Units to apply the changes to all of the connected Splitters.
Volume Adjustment
To control the volume of the HDMI Display Devices select the
Output tab then select the Audio Icon and adjust the volume
to the desired level.
Serial Control
1. Connect to the Splitter using a third party Serial Client.
2. Enter the commands found in the Serial and Telnet
Commands section.