User Manual

7
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Installing a Hard Drive
Warning! Hard Drives should be handled carefully, especially
when they’re transported. If you’re not careful with your
drives, you may lose data as a result. Make sure that you are
properly grounded by wearing an anti-static strap when you
install any computer component. If an anti-static strap isn’t
available, touch a large grounded metal surface for several
seconds to discharge any built-up static electricity.
1. Using the Screwdriver (included), remove the two Drive
Tray Screws from the Faceplate.
2. Slide the Drive Tray out of the Hard Drive Enclosure.
3. Place your Hard Drive next to the Drive Tray measuring the
length of the Hard Drive to determine the Drive Length
Hole that match the length of the Hard Drive (30, 42, 60 or
80 mm).
4. Place the Mounting Hardware (Stando) and Nut in the
Drive Length Hole that matches the length of the Hard
Drive and tighten them.
5. Gently slide the M.2 Connector on the Hard Drive into the
M.2 Connector on the Hard Drive Enclosure.
Note: The connector on your drive is keyed so that it only ts
one way.
6. Gently press the Hard Drive down aligning it with the
Stando.
7. Place the Screw into the Stando and tighten the screw to
secure the Hard Drive in place.