User Manual
8
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
2. (Optional) Remove the Adhesive Backing from the 100 x
25 x 20 mm Foam Blocks (x 2) and ax next to the Tabs,
towards the center of the Rear Plate.
3. (Optional) Remove the Adhesive Backing from the 100 x 15
x 12 mm Foam Blocks (x 2) and ax along the inside edge
on the top and bottom of the Rear Plate. (Figure 4)
Insert the iPad into the Tablet Enclosure Assembly
1. Insert the Power/Data Cable through one of the openings,
located in the rear/sides of the Rear Plate, and into the iPad.
(Figure 5)
2. Place the iPad into the Tablet Enclosure Assembly, routing
the Power/Data Cable around the EVA Pads. Ensure the
Power/Data Cable is routed without any sharp bends.
3. Attach the Front Plate to the Rear Plate and Lock the
Tablet Enclosure Assembly, using the Key. (Figure 6)
Figure 5
Figure 6
Charging
Cord
Front
Plate
Rear Plate