User Manual

Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: November 11, 2020
Secure Articulating Universal Tablet Mount
• (Optional -- for mounting) Electric Drill
• (Optional -- for mounting) Writing Utensil (i.e. Pencil, Pen, etc.)
• Phillips Head Screwdriver
Installation
Congure the Tablet Holder
1. Pull and hold the top Tab and extend the top Tablet Holder Arm until it reaches its
full length. (Figure 1)
2. Fold out the two lower Tablet Holder Arms.
3. (Optional -- for thin Tablets) Peel and stick the three Spacers over the existing
Screen Protection Pads located within the tips of all three Tablet Holder Arms.
Install the Tablet Holder
1. While the Table Holder Arm (Top) is fully extended, align the hole in the Tablet
Holder with the Pivot Point on the Tablet Stand. Continue to hold the Tablet
Holder. (Figure 2)
Washer
Product Diagram (SECTBLTDT)
Rear View
Component Function
1 Tablet Holder
• Holds a single Tablet
• Allows for 360° of rotation
2 Lock Slot x 2
• Deters theft
• Insert (up to) two K-Slot Style Laptop Locks (one
included, one sold separately)
3 Tablet Holder Arm
• Part of the Tablet Holder
• Three points of contact with the Tablet
• Integrated Spacers to prevent Tablet scratches
• (Optional) Spacers can be inserted into the Tablet
Holder Arms for thin Tablets
4 Tablet Stand
• Holds the Tablet Holder
• Allows for 180° of tilt
5
Cable Management
Holes
• Route the Tablet Charging Cable and K-Slot
Style Laptop Lock Cables through the Tablet
Stand
Requirements
For the latest requirements, please visit:
www.startech.com/SECTBLTDT
• Tablet
• Size: 7.9 - 13 Inch (200.66 - 330.2 mm)
• Thickness (Maximum): 0.374 Inches (9.5 mm)
*Tablet sold separately.
1
4
2
3
5
Figure 1
Tab
(Top)
Tablet Holder Arm
(Top)
Figure 3 Figure 4
Tablet Holder
Arm (Bottom)
Tab
(Bottom)
Figure 2
Upper Hole
M4 Screw
Lower Hole
Pivot Point