User Manual

18
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
5. In the top corner of the Front Door, pull the Lever down
and release it into the washer and hole in the Wall-Mount
Enclosure.
6. In the bottom corner of the Front Door, pull the Lever up
and release it into the washer and hole in the Wall-Mount
Enclosure.
Adjust the Depth of the Mounting Rails
The Mounting Rails come pre installed in the Wall-Mount
Enclosure. The Mounting Rails can be adjusted independently
in 3/4 inch (20 mm) increments to accommodate dierent sizes
of equipment.
Warning! Remove all equipment before adjusting the
Mounting Rails.
1. Use a Phillips Head Screwdriver to remove the Screw and
Cage Nut located in the upper and lower corners of the
Mounting Rails.
2. Install the Cage Nuts at the desired depth, along the upper
and lower Mounting Rails.
3. Slide the Mounting Rail to the depth of the Cage Nuts and
use a Phillips Head Screwdriver to install and tighten the
Screws that you removed in step 1.