User Manual

20
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
1. Decide where in the Server Rack you want to install the
equipment and insert the M6 Cage Nuts in the Mounting
Rails.
2. Line up the Mounting Holes on the equipment with the M6
Cage Nuts.
3. Insert the Screws through the Mounting Holes on the
equipment and into the M6 Cage Nuts.
4. Using a Phillips Head Screwdriver tighten the Screws,
being careful not to over-tighten.
Adjusting the Mounting Rails
1. Each Mounting Rail has four M6 Screws securing the
Mounting Rail to two Depth Adjustment Rails. Two M6
Screws are located at the top and two M6 Screws are
located at the bottom of a Mounting Rail.
2. Using a Phillips Head Screwdriver, remove the four M6
Screws and
3. Remove the Cage Nuts from the Depth Adjustment Rails,
by pinching the two Prongs on the back of the Cage Nut
inwards.
Note: Use a Cage Nut Tool (sold separately), If you are
having trouble removing the Cage Nuts from the Depth
Adjustment Rails.
4. Slide the Mounting Rail along the Depth Adjustment Rails
until you have reached the desired mounting depth.
Notes: The distance between each of the Mounting Rail
Adjustment Hole is 7/8 inch.