User Manual

Table Of Contents

To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support

2. Using an 14 mm Open-Ended Wrench, lower the Leveling

Feet (4 located next to each Casters) by turning it clockwise

until the base of the Leveling Feet are tightly pressed

against the surface, supporting the weight of the Server

Rack.

Grounding the Enclosure

Note: This product must be grounded. Do not use this prod-

uct without an earth ground connection.

1. Use an M6 Screw to attach a grounding wire to the

grounding point on the Server Rack, located on the inside

of the bottom of the Front and Back Doors and inside the

Side Panels.

2. Route the wire under the frame of the enclosure and

connect the wire to your facility’s earth ground connection.

Installing Equipment

Note: When you load equipment into this product, load

the heaviest equipment in the bottom rails rst. Continue

loading equipment in a descending order of weight, so that

the lighter equipment is installed in the upper sections of the

enclosure and the heavier items are on the bottom.

This Server Rack comes with M6 Cage Nuts and Screws but

the equipment you’re installing may come with mounting

hardware. Consult the documentation that came with the

equipment to determine the best mounting hardware that you

should use and how you should install it.