User Manual

17
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
20. Align the Screw Holes on the Bottom Plate w/ Cable
Management Slot with the Screw Holes on the interior of
the Side Panel, located on the front and back on the Side
Panel.
21. Insert two M6 x 12 mm Phillips Screws through the Screw
Holes on the Bottom Plate w/ Cable Management Slot
and into the Screw Holes on the interior of the Side Panel.
22. Using a Phillips Head Screwdriver, tighten the M6 x 12 mm
Phillips Screws, being careful not to over-tighten.
23. Repeat steps 8 - 10 to install the Back and Middle Bottom
Plates.
Note: Install the Back Bottom Plate before you install the
Middle Bottom Plate.
24. On the top of the Server Rack, align the Screw Holes in the
four corners on the Top Panel with the Screw Holes in the
four corners on the top of the Server Rack Frame.
Note: The Top Panel should t tightly against the corner
piece of the Top of the Server Rack.
25. Insert an M6 x 12 mm Hex Screw through the Screw Hole
on the Top Panel and into the Screw Hole on the Server
Rack Frame.
26. Using the M6 Hex Key, tighten the M6 x 12 mm Hex Screw,
Being careful not to over-tighten.
27. Repeat steps 13 - 14 for the remaining corners.
28. Insert a Door Hinge Pin into the Hinge Pin Hole in the
bottom corner of the Side Panel.