User Manual

16
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
11. Align the Leveling Feet with the Pre-Threaded Holes on
the bottom of the Server Rack Frame.
12. Using a 14 mm Wrench, tighten the Leveling Feet so that
the four Leveling Feet are all at the same height and are
shorter than the height of the Casters.
13. Align the Notch in the Plastic Corner Caps (x 4) with the
Screw Hole on each of the corners on the Server Rack.
14. Insert an M4 x 10 mm Flat Head Screw through the Screw
Holes in the Plastic Corner Cap and into the Screw Hole
on the Server Rack. Make sure that the head of the M4 x 10
mm Flat Head Screw is securing the Plastic Corner Cap in
place.
15. Using a Phillips Head Screwdriver, tighten the M4 x 10 mm
Flat Head Screws, being careful not to over-tighten.
16. Turn the Server Rack back over onto the Casters.
17. Align the Notch in the Plastic Corner Caps (x 4) with the
Screw Hole on each of the corners on the Server Rack.
18. Insert an M4 x 10 mm Flat Head Screw through the Screw
Holes in the Plastic Corner Cap and into the Screw Hole
on the Server Rack. Make sure that the head of the M4 x 10
mm Flat Head Screw is securing the Plastic Corner Cap in
place.
19. Using a Phillips Head Screwdriver, tighten the M4 x 10 mm
Flat Head Screws, being careful not to over-tighten.