User Manual
Table Of Contents
- Compliance Statements
- Safety Statements
- Warning Statements
- Product Diagram
- Product Information
- Package contents
- Requirements
- Ground the Enclosure
- Lock or unlock the front or rear door
- Remove the side panels
- Installing the Side Panels
- Access your cables
- Replacing the Cable Covers
- Reverse the front door
- Adjust the depth of the mounting rails
- Mount the enclosure to the wall
- Install equipment
15
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Replacing the Cable Covers
To put the cable access cover back on:
1. Place the cover over the cable access opening
2. Use a Phillips type screwdriver to insert the screws through
the cover and into the enclosure.
3. Tighten the screws.
Reverse the front door
To accommodate dierent rack congurations, you can reverse
the front door of the enclosure so that it opens to the left or
right of the enclosure.
1. In the top corner of the inside of the front door, pull the lever
down and move the top corner of the front door away from
the enclosure.
2. In the bottom corner of the inside of the front door, pull the
lever up and remove the front door from the enclosure.