User Manual

Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: August 6, 2019 8:15 AM
Product Diagram (PWRSTRPCLMP)
Component Function
1 Adjustable Clamp
• Used to hold the Power Strip in place.
• The Adjustable Clamp can support devices
between 40 mm - 60 mm (1.6” - 2.4”) wide.
2 EVA Form Pad (x 2) • Used to prevent surface scratches.
3 C-Clamp
• Used to secure the Power Strip Desk Clamp to
the edge of a surface.
• Clamps to surfaces up to 50 mm (2”) thick.
4 Thumb Screw
• Used to tighten the C-Clamp securing it to the
surface.
5 Silicone Pad (x 2) • Used to securely grip the clamped Device.
Requirements
For the latest requirements, please visit www.startech.com/PWRSTRPCLMP
Installation
1. Align the C-Clamp with the edge of the surface and slide it over the edge of the
surface.
2. Using the Thumb Screw tighten the C-Clamp until the C-Clamp is pressed tightly
against the surface.
Power Strip Desk Clamp
3. Slide the Device (e.g. Power Strip) into the Adjustable Clamp, securing the Device
in place. The Power Strip Desk Clamp will adjust to the size of the Device, between
40 mm - 60 mm (1.6” - 2.4”) wide.
Adjusting the Power Stripe Desk Clamp
4. Route the Power Cable down the back of the Power Strip Desk Clamp and through
the Cable Management Clip.
Routing the Cable
1
2
3
4
5