User Manual

To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support

2. Loosen the four M6 x 8 mm Hex Screws on the side of the

Wall Mount, using the 5 mm Hex Key.

3. Insert the M6 x 25 mm Hex Screw into the hole in the Wall

Mount and tighten (angle up) or loosen (angle down), using

the 5 mm Hex Key until the desired angle is met. (Figure 13)

4. Tighten the four M6 x 8 mm Hex Screws on the side of the

Wall Mount, using the 5 mm Hex Key.

5. Slide the Upper and Lower Decorative Covers together,

over the Wall Bracket, until the two Covers snap into place.

Adjust the Swivel

1. Loosen the Adjustment Screw, located next to the Grey

Adjustment Knob, using the 10 mm Wrench.

Figure 13

M6 x 25 mm Hex Screw

M6 x 8 mm

Hex Screws