User Manual

7
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
5. Gently slide the M.2 Connector on the Drive into the
corresponding M.2 Connector on the Adapter and press
the Drive down toward the adapter until the Drive is in
place.
Note: The M.2 Connector on the Drive is keyed so that it
only ts in the Adapter one way.
6. Place the Stando in the Drive Installation Hole that
matches the length of your drive.
7. Replace the Stando Installation Screw that you removed
in step 2 and tighten it in place.
8. Insert the Drive Mount Screw through the Drive Slot and
into the Stando. Use the Phillips Head Screwdriver to
tighten the Drive Mount Screw, securing the Drive in place.
9. Repeat Steps 5 - 7 to install the second Drive into the
Adapter.
Installing the Low-Prole Bracket
The Adapter can be mounted in both low-prole and full-
prole computer systems. By default, the full-prole bracket
comes pre-installed in the Adapter.
1. Use a Phillips Head Screwdriver to remove the two Bracket
Screws from the Adapter.
2. Remove the Full-Prole Bracket from the Adapter.
3. Align the Screw Holes on the Low-Prole Bracket with the
Bracket Holes on the back of the Adapter.