User Manual
Table Of Contents
- Compliance Statements
- Safety Statements
- Product Diagram
- Top View
- Rear View
- RJ45 Pin Assignment
- RS-232 DB9 Pin Assignment
- Product Information
- Package Contents
- Installation
- DIN Rail Mounting
- Load Default Settings/System Reset Button
- Load Default Settings
- System Reset
- Broadcast Search
- Using the Web Console
- Accessing the Web Console
- Changing/Setting a Login ID and Password
- Configuring System Network Settings
- System Status
- Load Default Setting
- Firmware Update
- Configuring TCP Mode
- Configuring UDP Mode
- UART
- Resetting the Device
- Virtual COM Software Operation
- Installing the Virtual COM Software
- Configuration the Virtual COM Software
- Setting Up COM Mapping
- TCP/UDP Settings
- LED Indicators
30
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Remote Port
• TCP Server – Disabled
• TCP Client – Assign the remote TCP port you wish to
communicate on.
• UDP – Assign the remote UDP port you wish to communicate
on
Enable Control Connection (TCP Server or Client Only)
• Enables/Disables control of the serial device on a remote
network. Using the IP address and port number allows the
user to gain control of the receiver from a remote location
when this is enabled.
Second(s) for Reconnection Interval
• Dictates the duration that the software will automatically
attempt to reconnect the COM port to the serial port on
the serial device server, for the purpose of keeping the
connection alive.