User Manual

22
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
• Parity Type: Set the parity of UART interface. The
NETRS2321P supports parity settings of Odd, Even, Space,
Mark or none.
• Stop Bit: Set the stop bit length of UART interface. The
NETRS2321P supports 1, 1.5 or 2 stop bits.
• Hardware Flow Control: Set the ow control mode of
UART interface as enabled or as none.
• UART Memory Overow Count: Shows the number of
overow bytes in network buer.
• UART FIFO Overow Count: Shows the number of
overows counted in the UART RX buer.
• Delimiter: This sets the Character 1 and/or Character 2 to
be used as the delimiter. When sending data from serial to
TCP the data is rst stored in the cache. When set, not until
the value of character 1 or 2 is received from the serial side
is the data released from the cache and sent to TCP.
• Silent time: If there is no data sent or received for the
number of milliseconds specied the connection is
dropped.
• Drop Character: drops the delimiter character of the
serial port when sending to TCP, (the receiver doesn’t
display the character).
4. Once you have completed making changes, press the
Update button to store the data.
5. Reset the device for the changes to take eect.