User Manual
Table Of Contents
- Compliance Statements
- Safety Statements
- Product Diagram
- Top View
- Rear View
- RJ45 Pin Assignment
- RS-232 DB9 Pin Assignment
- Product Information
- Package Contents
- Installation
- DIN Rail Mounting
- Load Default Settings/System Reset Button
- Load Default Settings
- System Reset
- Broadcast Search
- Using the Web Console
- Accessing the Web Console
- Changing/Setting a Login ID and Password
- Configuring System Network Settings
- System Status
- Load Default Setting
- Firmware Update
- Configuring TCP Mode
- Configuring UDP Mode
- UART
- Resetting the Device
- Virtual COM Software Operation
- Installing the Virtual COM Software
- Configuration the Virtual COM Software
- Setting Up COM Mapping
- TCP/UDP Settings
- LED Indicators
15
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
4. On the Load Default Settings screen, you can load and store
the factory default settings into EEPROM.
NOTE: Network settings and MAC address will not be
changed.
5. Press Load button to load default settings.
6. Reset the device for the changes to take eect.
Firmware Update
On this page, you can update the rmware via Ethernet.
Note: Pressing the ‘Load’ button will immediately erase the
ash with no further warning
1. From the Home screen, click the Administrator link on the
left-hand side of the screen.
2. From the drop down menu select the Load Default Settings
link.
3. The Load Default Settings screen will appear.
1. Press the Load button to erase ash.
2. Wait for erase process to complete.
3. There are two methods to do the Firmware Update action
(TFTP or Web):
Note: Please avoid loss of network connection, power or
other interruption during the rmware upgrade procedure.
• Web:
• Please type in or browse the target image le in the input