User Manual
Table Of Contents
- Compliance Statements
- Safety Statements
- Product Diagram
- Top View
- Rear View
- RJ45 Pin Assignment
- RS-232 DB9 Pin Assignment
- Product Information
- Package Contents
- Installation
- DIN Rail Mounting
- Load Default Settings/System Reset Button
- Load Default Settings
- System Reset
- Broadcast Search
- Using the Web Console
- Accessing the Web Console
- Changing/Setting a Login ID and Password
- Configuring System Network Settings
- System Status
- Load Default Setting
- Firmware Update
- Configuring TCP Mode
- Configuring UDP Mode
- UART
- Resetting the Device
- Virtual COM Software Operation
- Installing the Virtual COM Software
- Configuration the Virtual COM Software
- Setting Up COM Mapping
- TCP/UDP Settings
- LED Indicators
10
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
DIN Rail Mounting
• Attach the included DIN Rail brackets (one per side) using the
provided screws to the top DIN Rail screw hole (marked in the
above diagram), and clip to your DIN Rail
Load Default Settings/System Reset Button
Load Default Settings
• Press and hold this button for more than 3 seconds, then
release to load the factory default settings.
IP address: 10.1.1.1
Subnet Mask: 255.0.0.0
Login ID / Password: admin
System Reset
• Press and hold this button for more than 10 seconds, then
release to reboot the device (maintains conguration
settings)
Broadcast Search
• The Broadcast Search function is used to locate all
NETRS2321P devices that are connected to the same LAN
as your computer. Since the Broadcast Search function
searches by MAC address and not IP address, all NETRS2321P
connected to the LAN will be located, regardless of whether
or not they are part of the same subnet as the host.
NOTE: Broadcast packet packets are not passed through a
router. The VCom utility can only be used to monitor devices
in the same segment of the LAN.