User Manual
Table Of Contents
- Compliance Statements
- Safety Statements
- Product Diagram
- Top View
- Rear View
- RJ45 Pin Assignment
- RS-232 DB9 Pin Assignment
- Product Information
- Package Contents
- Installation
- DIN Rail Mounting
- Load Default Settings/System Reset Button
- Load Default Settings
- System Reset
- Broadcast Search
- Using the Web Console
- Accessing the Web Console
- Changing/Setting a Login ID and Password
- Configuring System Network Settings
- System Status
- Load Default Setting
- Firmware Update
- Configuring TCP Mode
- Configuring UDP Mode
- UART
- Resetting the Device
- Virtual COM Software Operation
- Installing the Virtual COM Software
- Configuration the Virtual COM Software
- Setting Up COM Mapping
- TCP/UDP Settings
- LED Indicators
9
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Product Information
Package Contents
• Serial over IP Device Server x 1
• Universal Power Adapter (NA/UK/EU/AU) x 1
• User Manual x 1
• DIN Rail Kit x 1
Installation
1. Plug in the power adapter and connect the RJ45 interface to
your LAN.
NOTE: Alternatively, you can also use a crossover cable to
connect the NETRS2321P directly to your system for the initial
conguration.
2. Press and hold the load default button for more than 3
seconds and less than 10 seconds, then release it. This will
return the serial device server to factory default and it will
respond to the IP address 10.1.1.1.
3. Congure the PC to the same IP domain.
4. Open a web browser and connect to http://10.1.1.1 to
open the conguration interface. The default login ID will be
“admin” and the password will be “admin”.
5. Once logged in, you will have access to all conguration
settings including the ability to change the IP address for the
device server.