User Manual

Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: February 13, 2019 2:46 PM
Product Diagram (MONSTND)
Rear View
Part Function
1 Top Plate • Used as a platform for a Monitor or Laptop
2 Upper Leg
• Attaches to the Top Plate
• Congurable with three height-adjustment
settings
3
Cable-Management
Slots
• Used for organizing and routing Cables
4 Lower Leg • Attaches to the Upper Leg
5
Height-Adjustment
Screw
• Used to secure the Upper Legs and Lower
Legs together
• Can be removed to adjust height settings
Monitor Riser - Metal - Height Adjustable
1
Requirements
• Phillips Head Screwdriver x 1
• Clean, Flat, and Stable Surface x 1
For the latest requirements please visit: www.startech.com/MONSTND.
Installation
Assembly
1. Place the Top Plate, top side down, onto a Clean, Flat, and Stable Surface.
2. Place the Upper Legs onto the Top Plate. Ensure the Holes in the Upper Legs are
aligned with the Holes in the Top Plate. The slanted portion of the Upper Legs
should be aligned with the slanted portion of the Top Plate.
3. Secure the Upper Legs to the Top Plate, using two M6x10 mm Screws for each
side. Fasten the M6x10 mm Screws using a Phillips Head Screwdriver.
4. Align the Lower Leg against the Upper Leg at the desired Monitor height setting.
5. Insert the Height-Adjustment Screw through the Upper Leg and into the Lower
Leg, then hand-tighten.
Note: Tighten the Height-Adjustment Screws by hand. Do not over-tighten.
6. Repeat steps 4 and 5 to attach the second Lower Leg.
7. Turn the Monitor Riser Assembly upright.
Operation
Height Adjustment
1. Place the assembled Monitor Riser, top side down, on a Clean, Flat, and Stable
Surface.
2. Remove the Height-Adjustment Screws.
3. Adjust the height of the Lower Legs to the desired height.
4. Insert the Height-Adjustment Screws through the Upper Legs and into the Lower
Legs, then hand-tighten.
5. Turn the Monitor Riser Assembly upright.
2
5
4
3