User Manual

9
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
5. Mark the location of the Mounting Holes using a Writing Utensil. These
marks can be used as a guide to indicate where the Mounting Screws will
be installed in the surface.
6. Install the Bracket Screws (x4) through the Mounting Bracket and into
the mounting surface, using a Phillips Head Screwdriver. Be careful not to
overtighten.
Note: To prevent the Mounting Screws from penetrating the opposite side
of the installation surface, be conscious of the size of the Mounting Screw
compared to the depth of the surface.
Powering the Module
1. On the bottom of the Docking Station Module, connect the Universal
Power Adapter to the DC 20V 6A Port.
2. Tighten the Lock Screw on the Universal Power Adapter, to ensure
connectivity.
3. Connect the other end of the Universal Power Adapter into an appropriate
power source.
Note: By default the Power Button on the Docking Station Module is set
to On. If the LED Indicator on the Docking Station Module does not light
up when connected to the Universal Power Adapter and power is present,
press the Power Button to turn on the Docking Station Module. The LED
Indicator will light up white.
Connecting Devices to the
Bottom of the Module
Audio Options
Speaker Out:
The Speaker Out Port is used to connect an Audio Device (e.g. Speakers) to the
Docking Station Module for use with the connected Host Computer.
1. Connect a 3.5 mm Audio Cable to the Speaker Out Port on the bottom of
the Docking Station Module.