User Manual
Table Of Contents
- Compliance Statements
- Safety Statements
- Warning Statements
- Product Diagram
- Top View
- Bottom View
- Product Information
- Package Contents
- Requirements
- Installation
- Mounting
- Powering the Module
- Connecting Devices to the Bottom of the Module
- Audio Options
- HDMI In
- HDMI Out
- RJ45 Port (Network Device)
- USB-A Port
- Connecting Devices to the Top of the Module
- Connecting a Host Computer to the Module
- USB-C Port
- USB-B Port
- HDMI In Port (Pass Through)
- USB-A Port
- LED Indicators
- Power
- RJ45 Port
- Configuration
- Configuring a Display
- Display Preference
- Connectivity Diagram
8
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Installation
Note: StarTech.com is not responsible for any damages related to the instal-
lation of this product.
See the Installation section in the Modular Table Box (BOX4MODULE) or
Single-Module Table Box (BEZ4MOD) User Manual for instructions on how to
install a module (found at www.startech.com/BEZ4MOD or www.startech.com/
BOX4MODULE).
Mounting
Installation Requirements:
• Mounting Bracket x 1
• Bracket Screws (M5 x 20 mm) x 4
• Module Screws (#6-32 x 3/16) x 8
• Writing Utensil x 1
• Phillips Head Screwdriver x 1
Note: Before mounting the Module, consider the desired position of the
ports (top and bottom) as it will aect the mounting orientation .
1. Align the Mounting Bracket with four of the Mounting Holes on the
Module.
Note: The Module has four Mounting Holes on each side on the Module,
which gives you two dierent mounting options.
2. Insert the Bracket Screws (x4) through the Mounting Bracket and into the
Mounting Holes.
3. Tighten the Mounting Screws using a Phillips Head Screwdriver, be
careful not to overtighten.
4. Before installing the Mounting Bracket, measure and position the
Mounting Bracket in the desired location. The Module can be mounted on
a vertical or horizontal surface.
Note: Depending on the surface you are using to install the product, you
may need to drill pilot holes prior to installing the screws into the surface.