User Manual

22
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
1. Place the Rear Cover over the VESA Mounting Plate and
Front Bracket Cover. Align the holes in the top of the Rear
Cover with the holes in the top of the VESA Mounting
Plate. Align the holes in the bottom of the Rear Cover with
the holes in the bottom of the Front Bracket Cover.
(Figure 16)
2. Insert four M6 x 12 mm Screws into the holes aligned in
step 1 and tighten, using an appropriately sized Phillips
Head Screwdriver.
Operation
Adjust the Tilt of the TV
1. Remove the four M6 x 12 mm Screws installed in step 2 of
Attach the Rear Cover.
2. Remove the Rear Cover.
3. Remove the bottom two M8 x 20 mm Screws, that attach
the VESA Mounting Plate to the Upper Columns, using the
5 mm Hex Key. (Figure 9)
4. Loosen the top two M8 x 20 mm Screws, that attach the
VESA Mounting Plate to the Upper Columns, a quarter
turn, using the 5 mm Hex Key.
Note: Do not over-loosen or remove the M8 x 20 mm
Screws.
5. Tilt the TV to and aligning the lower holes in the VESA
Mounting Plate with the holes in the Upper Columns.
6. Insert two M8 x 20 mm Screws through the holes in the
VESA Mounting Plate and into the Upper Columns.
Tighten, using the 5 mm Hex Key.