User Manual

21
1. Route the Cables through the Cable Management Slots in
the Columns.
2. Peel the plastic backing o the Cable Clip Holders and stick
them to the desired locations within the VESA Mounting
Plate. (Figure 12)
Note: Excess slack can be coiled and secured using two
Cable Clips. (Figure 13)
3. Thread the Cable Clips through the Cable Clip Holders.
4. Secure the Cables with the Cable Clips and tighten.
5. (Optional) Remove up to two Panels from the notch in each
Cable Cover, using a pair of Needle-Nose Pliers. (Figure 14)
6. Insert the Cable Covers into the Cable Management Slots
in the Columns, routing the Cables through the notch in
each Cable Cover. (Figure 15)
Attach the Rear Cover
Figure 16
Rear
Cover
M6 x
12 mm
Screws