User Manual

1. Place the TV on a padded surface, screen side down, so the

back of the TV is accessible. (Figure 7)

2. (Optional) Identify and remove the pre-installed VESA

Hardware from the back of the TV.

Note: Not all TVs will have placeholder VESA Hardware.

Only remove the four Screws for the VESA Mount. Do not

remove any of the screws from the TV’s structural assembly.

3. (Optional -- for TVs with recessed VESA Mounting

Holes, for TVs with uneven rear geometry, or to adjust

the engagement depth of the provided Screws) Add the

necessary number of Small and/or Large Spacers between

the VESA Extension Arms (L+R) and TV.

4. Align the hole in the thin portion of the VESA Extension

Arms (L) with the VESA Mounting Holes on the left rear of

the TV. (Figure 6)

5. Repeat step 4 with the VESA Extension Arms (R) for the

right side.

6. Align the holes in the VESA Mounting Plate with the holes

in the VESA Extension Arms (L+R). The Directional Arrow

on the VESA Mounting Plate should be pointing towards

the top of the TV.

7. Insert eight M8 x 8 mm Screws through the VESA

Mounting Plate and into the VESA Extension Arms (L+R)

and tighten, using the 5 mm Hex Key.

8. Place a Rectangular Washer over each VESA Mounting

Hole.

9. Thread the appropriately sized M-Type Screws (e.g. M5 x

14 mm Screws) through the Rectangular Washers, VESA

Mounting Plate, (Optional) Spacers, and into the TV.

To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support