User Manual

To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support

Attach the Upper Columns to the Base Columns

1. Slide one Shelf Bracket onto each Base Column. Slide the

Shelf Brackets past the Screw Holes, located in the Base

Columns. (Figure 4)

2. Insert the narrow end of the Upper Columns into the tops

of the Base Columns.

Note: Ensure the Cable Management Slots in the Upper

Columns are facing inwards.

3. Insert four M6 x 8 mm Screws into the holes located in the

front and rear of each Base Column and tighten, using the 4

mm Hex Key.

4. Slide the Shelf Brackets up to align the opening in each

Shelf Bracket with the inward facing holes on both Base

Columns.

5. Insert two M6 x 12 mm Screws into the inward facing holes

in both Base Columns and tighten, using an appropriately

sized Phillips Head Screwdriver.

Figure 4

Upper

Columns

Base

Columns

Shelf

Brackets

4 mm

Hex Key

M6 x 8 mm

Screws

Cable

Management

Slot