User Manual

Instruction Manual
3
5. Connect the SATA power cable and the SATA data cables to the appropriate ports
provided on the back of the rear panel of the drive frame.
Installing the hard drive into the drive frame
1. Pull the spring lock to open the front door.
2. Position the hard drive near the entry of the frame, with the label of the hard drive
facing up, and the rear panel of the hard drive aimed towards the inside of the
computer.
3. Gently push the drive into the frame until the locking arm begins to close.
4. Secure the drive in the frame by continuing to close the locking arm. Gently apply
pressure to the locking arm, until you hear the ‘click’ of the spring lock.
5. Optional: To lock the drive in the frame, insert the key provided into the keyhole at
the front of the drive bay. Turn the key 90° to the right, and remove the key.
Removing the hard drive from the drive frame
1. If you opted to lock the drive in place, insert the key into the keyhole. Turn the key
90° to the left, and remove the key.
2. Gently, but rmly open the locking arm until it is out of the path of the hard drive removal.
3. Once the locking arm is open, slowly pull the hard drive out of the frame.
4. Return the locking arm to the secured position.