User Manual
Table Of Contents
- Safety Statements
- Warning Statements
- Product Diagram
- Product Information
- Package Contents
- Requirements
- Installing the Tilt Adjustment Knobs
- Installing the Bubble Level
- Mounting the Wall Bracket
- Attaching the Vertical Brackets (Flush Mounting)
- Recessed Mounting
- Spacer Combination
- Mounting the TV
- Adjusting the Tilt
- Removing the TV
20
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
6. Use a Phillips Head Screwdriver to tighten the screws. Do
not over-tighten the screws.
Note: If you encounter resistance, stop tightening. Failure to
do so could result in damage to the TV.
Recessed Mounting
1. Determine the depth and diameter of the mounting holes
located on the back of the TV.
2. Once you determine the correct depth and diameter of the
hardware needed.
3. Place the Spacers (depending on your TV conguration)
over the Screw Holes on the back of the TV.
Note: Refer to the Spacer Combination table for dierent
hardware combinations.
4. Align one of the Vertical Brackets (with the Adjustment
Knob facing outward) with the Mounting Holes of the back
of the TV.
5. Place a Rectangular Washer over the Screw Holes on the
Vertical Bracket.