User Manual

Instruction manual
12
Mount a TV with a ush mounting surface
To accommodate dierent TV designs, the FPWARTB1M comes with ve sets of screws
of dierent lengths and diameters, two sizes of washers, and two sizes of spacers.
1. To select the combination of mounting hardware that you need to use to attach the
VESA mount extensions to the TV, complete the following:
• Determine the depth of the mounting holes on the TV.
• Determine the diameter of the mounting holes on the TV.
Note: If you’re using a TV with a ush mounting surface, you don’t need to use any of
the provided spacers.
2. Position the end of the TV mount with the circle closest to the top edge of the TV.
3. Line up the TV mount or the VESA mount extensions with the mounting holes on
the back of the TV.
4. Place the small washers or large washers over the TV mount or the VESA mount
extensions.
5. Insert the M5x14 mm screws or the M6x14 mm screws through the washers, TV
mount or VESA mount extensions, and into the back of the TV.
6. Use a Phillips screwdriver to tighten the screws. (gure 4)
Warning! Do not over-tighten the screws. If you encounter resistance while you’re
tightening the screws, stop tightening. Failure to do so could result in damage to the
TV.
gure 4
Washer
Circle
VESA mount extension pictured
M5x14 mm screw
M6x14 mm screw