Operation Manual

Instruction Manual
2
NOTE: If only installing one drive, continue to Step 5.
4. Turn the BRACKET25X2 back over so that the label on the installed HDD/SSD is
facing upward. Then place your second 2.5” HDD/SSD on top of the rst drive so that
the HDD/SSD side installation holes match the Top Drive Mounting Holes on the
BRACKET25X2.
5. Hold the HDD/SSD into place, and x 4 screws from the included screw kit through
the Top Drive Mounting Holes on the BRACKET25X2 into the side installation holes
on the second HDD/SSD.
6. Ensure your computer is powered o, disconnected from an AC electrical outlet, and
drained of any remaining power.
7. Open your computer case (refer to the computer user manual for details), and place
the BRACKET25X2 with installed HDD/SSDs into an available 3.5” installation bay,
lining up the bay installation holes on the BRACKET25X2 (pictured below), with
installation holes on the 3.5” bay.