Operation Manual

Instruction Manual
1
Product Diagram
Top Drive
Mounting
Holes
Bottom
Drive
Mounting
Holes
1 A
2 B
3 C
4 D
Introduction
Packaging Contents
• 1x 2.5” Mounting Bracket
• 4x Flat screws and Washers (bottom drive)
• 4x M3 x 5mm Screws (top drive)
• 4x 6-32 Screws (mounting the bracket into the PC)
• 1x SATA Power Y cable
• 2x 18” SATA DATA Cables
• Instruction Manual
Installation
WARNING! Computer equipment can be severely damaged by static electricity. Be sure
that you are properly grounded before opening your computer case or touching your
hard drive.
1. Place the BRACKET25X2 so that it is facing upward on a table like the photo above.
2. Place the rst 2.5” HDD/SSD so that it is label up on the mounting bracket, line up
the HDD/SSD bottom installation holes on the bottom of the drive to match The
Bottom Drive Mounting Holes pictured above.
3. Turn the Bracket over holding the drive into place, and x 4 screws from the
included Screw kit through the Bottom Drive Mounting Holes, into the HDD/SSD
bottom installation holes.