User Manual

Quick-Start Guide

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.

Manual Revision: September 9, 2019 10:18 AM

Product Diagram (BRACKET125PTP)

Component Function

1 Hard Drive Slot

• Used to secure a 2.5” Solid State Drive or

Hard Drive in the Mounting Bracket.

2 Plastic Pegs

• Used to secure the Mounting Bracket to the

Computer Chassis.

3 Handle

• Used to insert/remove the Mounting Bracket

into/out of the Computer Chassis.

Requirements

For the latest requirements, please visit www.startech.com/BRACKET125PTP

Packaging Contents

• 2.5” SSD/HDD Mounting Brackets x 5

• Plactic Pegs x 30

• Quick-Start Guide x 1

2.5” SSD/HDD Mounting Bracket for 3.5” Bay | Tool-less | 5 Pack

Installing a Hard Drive

1. Remove the Plastic Pegs (x 6) from the center of the Mounting Bracket by gently

twisting the Plastic Peg until it snaps o of the plastic molding.

2. Slide the Hard Drive into the Hard Drive Slot on the Mounting Bracket towards

the Handle, label side down, with the Hard Drive Connector facing out.

Inserting a Hard Drive into the Mounting Bracket

Installing the Mounting Bracket

1. Turn o the Computer and any connected Peripheral Devices (e.g., printers,

external hard drives, etc.).

2. Unplug the Power Cable from the back of the Computer and disconnect any

Peripheral Devices.

3. Remove the Cover from the Computer Case.

Note: Please refer to the manufacturer’s manual for instruction on how to remove the

Computer Case Cover.

4. Slide the Mounting Bracket (label side up) into a 3.5” Hard Drive Slot, aligning

the Mounting Holes on the Mounting Bracket with the Mounting Holes on the

Computer Chassis.

Sliding the Mounting Bracket into the 3.5” Hard Drive Slot

PAGE 1
Quick-Start Guide 2.5” SSD/HDD Mounting Bracket for 3.5” Bay | Tool-less | 5 Pack Product Diagram (BRACKET125PTP) Installing a Hard Drive 2 3 1. Remove the Plastic Pegs (x 6) from the center of the Mounting Bracket by gently twisting the Plastic Peg until it snaps off of the plastic molding. 2. Slide the Hard Drive into the Hard Drive Slot on the Mounting Bracket towards the Handle, label side down, with the Hard Drive Connector facing out.
PAGE 2
5. Insert the Plastic Pegs (x 4) through the Mounting Holes on the Computer Chassis and into the Mounting Holes on the Mounting bracket. You should hear an audible click when installing the Plastic Pegs. Inserting the Plastic Pegs into the Computer Chassis 6. Connect a Power Connection from the Computer’s Power Supply to the Hard Drive’s Power Connector. 7. Use the appropriate cable and connect the Hard Drive to the Host Controller. 8. Place the Cover back on the Computer Case. 9.