User Manual
Table Of Contents
- Compliance Statements
- Safety Statements
- Warning Statements
- Product Diagram
- Product Information
- Package Contents
- Requirements
- Installation
- Cutting the Table/Surface
- Installing the Module in the Modular Table Box
- Installing the Lacing Bar (Cable Organization)
- Installing the Modular Table Box into a Surface
- Assembling the Cable Management Module
- Assembly Requirements:
- Installing the Cable Management Module
10
To view manuals, videos, drivers, downloads, and more visit www.startech.com/support
6. Insert the Jigsaw Blade into one of the pilot holes and carefully cut into the
surface, along the guide lines to connect the four pilot holes, cutting the
installation hole out of the table’s surface.
Installation Hole
Installing the Module in the Modular Table Box
Notes: Modules can be mounted using three dierent mounting depths
depending on your conference table setup.
See Assembling the Cable Module and Installing the Cable Module if you
intend to use the Cable Module in your Modular Table Box conguration.
1. Determine the mounting depth of the Module inside the Modular Table
Box. Take into consideration cable bend radius and the amount of clearance
needed to properly close the Modular Table Box lid while cables are
connected to the Module.