User Manual
ManualsBrandsStartech ManualsDisplays & ProjectorsStarTech.com Desk Mount Monitor Arm, Heavy Duty Ergonomic VESA Monitor Arm, Single Display up to 9kg, Full Motion, Height Adjustable, Articulating, Aluminum, C-Clamp/Grommet, Silver Small Footprint Design - mounting kit - adjustable arm - for LCD display
Instruction manual
14
Attach a monitor
Warning! Attaching a monitor is a two-person job. Do not attempt to complete this
task by yourself.
To accommodate dierent monitor designs, the ARMPIVOTHD comes with two sets of
screws that are dierent lengths and diameters, and a set of spacers.
To select the appropriate screws for the type of monitor that you’re using, complete
the following:
• Determine whether the back of the monitor is ush or inset.
• Determine the depth of the mounting holes on the monitor.
• Determine the diameter of the mounting holes on the monitor.
1. Do one of the following:
• If required, place the spacers (18) over the mounting holes on the back of your
monitor, and position the VESA monitor mount (2) over the spacers. Make sure
that you position the VESA monitor mount so that the arrow on the back of the
VESA monitor mount is pointed towards the top of the monitor.
• Position the VESA monitor mount (2) over the mounting holes on the back of
your monitor. Make sure that you position the VESA monitor mount so that the
arrow on the back of the VESA monitor mount is pointed towards the top of the
monitor.
2. Position the four washers (17) over the holes on the VESA monitor mount.
3. Insert the four M4x12 mm thumbscrews (15) or the four M5x12 mm screws (16)
through the washers, the VESA monitor mount, and into the back of the monitor.
(gure 11)
4. Use a Phillips screwdriver to tighten the screws.
Warning! Do not over-tighten the screws. If you encounter resistance while you’re
tightening the screws, stop tightening. Failure to do so could result in damage to the
monitor.