User Manual

12
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Figure 10
Route the Cables
ARMDUOSS comes with Cable-Management Clips that you can use to direct the
Monitor Cables along the Crossbar and down the Pole so that they are out of your
way.
Note: Make sure that the Cables you are routing are unplugged before you
complete the following steps.
1. Attach the two Cable-Management Clips (Crossbar) to the Crossbar
(Figure 11). Each Clip snaps into place. If necessary, you can move the Cable-
Management Clips (Crossbar) right or left along the Crossbar.
2. Run the Cable coming from each of the Monitors through the corresponding
Cable-Management Clips (Crossbar) (Figure 12).