User Manual

Instruction manual
6
5. Turn the 2-in-1 desk mount over and use one of the M3 Allen keys (3) to insert four
M5x14 mm hex screws through the desk mount and into the base of the mount
(gure 7).
gure 7
M5x14 mm hex screw
(x4)
M3 Allen key
Use the grommet mount to attach the ARMDUAL30
1. Remove the plastic from the base cushion (4) and attach it to the bottom of the
base mount. Make sure that you line up the hole on the base mount with the
corresponding hole on the base cushion.
2. Position the base mount over the grommet hole (gure 8).
Base cushion
(not pictured)
Base mount
Desk thickness
20 to 50 mm
Desk hole
10 to 60 mm
3. Place the thumbscrew through the grommet hole in your desk or table and into the
pole on the base mount.
4. Turn the thumbscrew clockwise to tighten it (gure 9).
gure 9
Thumbscrew
gure 8