User Manual

Instruction manual
5
Convert the grommet mount to a desk mount
By default, the ARMDUAL30 comes with the desk mount preassembled. If you
assemble the grommet mount and want to switch back to a desk mount, you will
need to use the screws and hardware that you removed when you converted the
ARMDUAL30 to a grommet mount.
1. Use a Phillips screwdriver (not included) to insert four M6x12 mm screws into the
two halves of the desk mount (1) (gure 4).
Note: Depending on the height of the desk or table, use the top four holes or the
bottom four holes in the desk mount.
gure 4
or
M6x12 mm
screws
M6x12 mm
screws
2. Insert the thumbscrew through the hole in the desk mount (gure 5).
gure 5
Thumbscrew
3. Place a male washer onto the thumbscrew.
4. Place a Phillips M3 screw through a female round washer, the plate, and into the
male washer on the thumbscrew (gure 6).
gure 6
M3 screw
Female washer
Plate
Male washer
Thumbscrew