User Manual

Instruction manual
There are four main tasks that you need to complete when you assemble the
ARMDUAL30: Attach the ARMDUAL30 to a desk or table, attach the monitor arms,
attach the monitors, and route the monitor cables.
Attach the ARMDUAL30 to a desk or table
By default, the ARMDUAL30 comes with the desk mount preassembled.
Convert the desk mount to a grommet mount
1. Turn the 2-in-1 desk mount (1) over so that the pole faces downwards. Use one of
the M3 Allen keys (3) to remove the four M5x14 mm hex screws that are holding the
base of the pole to the desk clamp (gure 1).
M5x14 mm hex screw
(x4)
M3 Allen key
2. Use a Phillips screwdriver (not included) to remove the M3 Phillips screw from the
plate on the desk mount (gure 2).
3. Remove the plate, two washers, and the thumbscrew from the bottom of the desk
mount (gure 2).
gure 2
M3 screw
Washers
Plate
Thumbscrew
4. Use a Phillips screwdriver (not included) to remove the four M6x12 mm screws that
are holding the two parts of the desk mount together (gure 3).
gure 3
M6x12 mm screws
gure 1
4