VGA Video Extender over Cat 5 with RS232 ST121UTP232 *actual product may vary from photos DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr.startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com For the most up-to-date information, please visit: www.startech.
FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents Introduction.............................................................................................1 Packaging Contents.................................................................................................................................. 1 System Requirements............................................................................................................................... 1 Installation..........................................................................
Introduction Packaging Contents • 1 x ST121UTP232 Transmitter unit • 1 x ST121UTP232 Receiver unit • 2 x Power Adapter • 2 x Rubber Stopper set • 1 x Instruction Manual System Requirements • VGA enabled video source and display • Serial Device: RS232 only • Available power outlet for both Transmitter/Receiver units • Point-to-Point Cat5 UTP Ethernet connection Instruction Manual 1
Installation This product is composed of two separate units: the Transmitter Unit and the Receiver Unit. The Transmitter Unit takes the output from a VGA and/or RS-232 Serial data source and transmits it to the Receiver unit over Category 5 Ethernet cable. The signal source (VGA and/or Serial) is connected to a Transmitter unit, which transmits the signal to the Receiver unit, up to 300m away.
Front View - Receiver Unit DB9 output VGA output Power connector/LED Rear View - Receiver Unit Contrast/ Brightness Adjustment RJ45 port Preparing Your Site Prior to installation, please ensure that the site is prepared to accommodate the location of the Transmitter and Receiver units. 1. Determine where the local computer will be located and set up the computer. 2. Determine where the remote display(s) will be located and place/mount them appropriately. 3.
Please note that the following instructions assume that both Serial and VGA connections will be used. If you are using the extender with only serial or only VGA, please disregard any steps pertaining to the unused connection. Installing the Transmitter Unit 1. Place the Transmitter Unit near the computer/video source. 2. Switch off the computer and disconnect any existing VGA connections. 3.
Specifications 2 x DE-15 VGA female Connectors (Transmitter) 1 x 9-pin DB9 male 1 x RJ45 2 x DE-15 VGA female Connectors (Receiver) 1 x 9-pin DB9 male 1 x RJ45 RGB Analog (75Ω, 0.7Vp-p) + DATA Input Signal H/V Sync Separated (TTL) RS232 Data Maximum Video Resolution 1600x1200 Maximum Distance 1000 ft. (300m) Video Bandwidth 150MHz Horizontal Frequency Range 30-95KHz Vertical Frequency Range 50-180Hz Power Supply 12VDC, 500mA Dimensions 44.0mm x 133.0mm x 70.
Technical Support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. For the latest drivers/software, please visit www.startech.com/downloads Warranty Information This product is backed by a two year warranty. In addition, StarTech.
Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise. StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you find the parts that connect your solutions. We make it easy to locate the parts, and we quickly deliver them wherever they need to go. Just talk to one of our tech advisors or visit our website.
