User Guide

Quick-Start Guide

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.

Manual Revision: February 3, 2023 1:22 PM

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support

Product Diagram (U02442-USB-EXTENDER)

Front View

Rear View

79ft (24m) USB 2.0 480 Mbps Active Cable with 4-Port USB Hub

Component Function

1 4x USB-A Peripheral Ports

• Connect USB-A Peripheral devices

• USB 2.0 (480 Mbps)

• Supports up to 5 V and 0.5 A (2.5 W)

2 Power LED

• Indicates if the USB Active Cable with

USB Hub is receiving power from the Host

Computer or the Power Adapter

• Solid Green = Power

• O = No Power

3 USB-A Host Cable

• Connect to a USB-A Port on a Host Computer

• USB 2.0 (480 Mbps)

4 DC Power Port

• Connect the USB Active cable with USB Hub

to a Power Source using the included Power

Adapter

• Recommended 5 V and 2 A

Package Contents

• USB Active Cable with USB Hub x 1

• Power Adapter x 1

• Quick-Start Guide x 1

Requirements

For the latest manuals, product information, technical specications, and declarations

of conformance, please visit:

www.StarTech.com/U02442-USB-EXTENDER

• Computer with a USB-A Port z

• USB peripheral device with required USB-A cables

Warnings!

Read the entire Quick-Start Guide and ensure the instructions are fully understood

before using this product.

Never operate this product if parts are missing or damaged.

*Product may vary from image

4 1

PAGE 1
Quick-Start Guide 79ft (24m) USB 2.0 480 Mbps Active Cable with 4-Port USB Hub Product Diagram (U02442-USB-EXTENDER) Component Front View 4x USB-A Peripheral Ports • Connect USB-A Peripheral devices • USB 2.0 (480 Mbps) • Supports up to 5 V and 0.5 A (2.5 W) 2 Power LED • Indicates if the USB Active Cable with USB Hub is receiving power from the Host Computer or the Power Adapter • Solid Green = Power • Off = No Power 3 USB-A Host Cable • Connect to a USB-A Port on a Host Computer • USB 2.
PAGE 2
Installation 1. Connect the USB-A Host Cable to a USB-A Port on the Host Computer. No drivers are needed for the USB active cable with USB hub. 2. Connect the Power Adapter to a Power Outlet and into the DC Power Port of the USB Active cable with USB Hub. 3. Connect a USB Peripheral Device to any of the four USB-A Peripheral Ports. Some USB peripheral devices may need drivers to finish their installation.