User guide

Instruction Manual
6
Video Calibration (Remote Unit only)
Video Calibration allows the user to adjust the equalization, gain and RGB skew on
the Remote Unit to optimize video performance based on the length of the UTP cable
being used, as well as other factors that may aect the signal.
There are 16 levels of coarse tuning and up to 128/256 scales of ne tuning available for
adjustment of the equalizer and gain. Skew adjustment for red, green and blue colour
channels come in 8 levels of coarse adjustment and 16/32 scales of ne adjustment.
NOTE: Video Calibration is only available when the UTP cable is connected and the
Remote unit has control of the Host computer system.
To enter Video Calibration Mode:
left [CTRL] - left [CTRL] - [F11]
To enter Video Calibration Mode while in Compatibility Mode:
left [CTRL] - left [CTRL] - [E] - [F11]
When in Video Calibration mode, the Num Lock and Scroll Lock LEDs on the keyboard
will ash simultaneously. Video calibration can now be performed. Refer to the table
for the dierent adjustment options.
Before Video Calibration
After Video Calibration