Instruction manual

Instruction Manual

Beep Codes

Some of the keyboard command sequences you issue to the Host Unit

have multiple possible settings. The unit will beep to indicate what setting

you have selected for the command you issued. (A short beep followed

by a long beep indicates an invalid command.)

[Ctrl] - [Ctrl] - [Alt]+[E] (Compatibility Mode)

1 beep: disabled

2 beeps: enabled

[Ctrl] - [Ctrl] - [F3] (Inactivity Interval for Auto Mode)

1 beep: 5 seconds

2 beeps: 15 seconds

3 beeps: 30 seconds

4 beeps: 60 seconds

[Ctrl] - [Ctrl] - [F4] (Typematic Rate)

1 beep: 6 characters/sec.

2 beeps: 12 characters/sec.

3 beeps: 20 characters/sec.

4 beeps: 30 characters/sec.

Note: Commands described in the [Key] - [Key] format are keys that

must be pressed in order on the keyboard. Commands described in the

[Key]+[Key] format must be pressed simultaneously.

Note: If the Num Lock, Caps Lock, and Scroll Lock lights are ﬂashing in

unison on the keyboard, the other Unit has control of Computer A. You

will not be able to use the computer or issue commands until the other

unit has ﬁnished using the computer.

Note: If the Extender is operating in Compatability Mode ([Ctrl] - [Ctrl] -

[E] hotkey sequence), you must enter [Ctrl] - [Ctrl] - [E] - [E] to access

port E on the attached KVM switch.