Owner's manual
Instruction Manual
15
Hotkey Beeper Control
The Beeper can be hotkey toggled On and O. To toggle the Beeper, do the following:
1. Invoke HSM (see “Invoking Hotkey Setting Mode”).
2. Press and release the [B] key.
The Beeper toggles On or O. The Command Line displays Beeper On or Beeper O for
one second, then the message disappears and you automatically exit Hotkey Mode.
Disable Port Switching Keys
To disable the Port Switching Keys ( [Scroll Lock], [Scroll Lock] / [Ctrl], [Ctrl] ), do the
following:
1. Invoke HSM (see “Invoking Hotkey Setting Mode”).
2. Press [X] [Enter].
Restore Default Settings
To reset the KVM Switch to its default hotkey settings, do the following:
1. Invoke HSM (see “Invoking Hotkey Setting Mode”).
2. Press [R], [Enter].
Invoke Firmware Upgrade Mode
To set the KVM Switch to Firmware Upgrade Mode, do the following:
1. Invoke HSM (see “Invoking Hotkey Setting Mode”).
2. Key in: upgrade.
3. Press [Enter].
The front panel port LEDs ash to indicate Firmware Upgrade Mode is in eect.
Please Note: To exit Firmware Upgrade Mode, you must power o the switch.