Owner's manual

Instruction Manual
8
please write this number down and keep it for future reference. Once you locate the
MAC address of your unit in the DHCP log, you can match it to its leased IP address and
proceed with the Web conguration.
Please note:
• Once you have located the IP address of the SVxx53DXI and wish
to proceed with the Web conguration, do not power o the unit or
your DHCP server, since the Enterprise Class KVM might lease a
dierent IP address. Should this happen, re-examine the DHCP log to
verify the IP address again.
• DHCP functionality is not aected if you also connected the WAN
port on the SVxx53DXI to your network (see below). However, it is not
recommended that you connect both the WAN and LAN ports to the
same network segment.
Web Conguration Using Static IP
The DHCP access method described above would not apply to networks that rely
on static IP addresses (every device has a pre-congured IP address that does not
change). To accommodate this type of installation, the WAN port on the rear panel of
the SVxx53DXI is factory-congured with its own IP address.
Please note:
• If you connected the LAN port on the rear panel of the unit to your
network, but did not connect the WAN port, you must disconnect the
Ethernet cable from the LAN port and move it to the WAN port before
attempting a static IP installation. (If desired, you can return the cable
to the LAN port if you congure it with a static IP address during the
conguration process.)
If you have connected both the LAN and WAN ports on the unit to your
network, you may proceed with a static IP Web conguration.