Manual

Instruction Manual
6
Scan Time
Four options are available for users to set the Scan Time duration, it Includes 3, 8, 15 and 30
seconds.
Note: Scan Time is set to 3 seconds by default.
To adjust Scan Rate, set the scan time of duration before switching to the next computer:
Left <CTRL> + Left <CTRL> + F3
The KVM Switch generates 1 to 4 beeps indicating a scan time duration for 3, 8, 15 or 30 seconds
respectively.
USB-Port Rule
There are two settings for USB-Port Rule: ON or OFF.
When set to ‘ON’, the USB Hub port follows computer selection.
When set to ‘OFF’, the USB Hub port stays on the currently selected PC port.
USB 1: pressing the hotkey below to turn ON/OFF the USB-Port Rule:
Left <CTRL> + Left <CTRL> + F7
To change the port that the USB hub stays on to the currently selected port, press the following
hotkey:
Left <CTRL> + Left <CTRL> + U
NOTE: Please make sure that linking procedure of USB device has been accomplished before
switching to the next computer.