Datasheet

Before You Begin
To ensure a quick and easy device installation, please read through this section carefully
before attempting to install the switch.
Contents
This package should contain:
•1 x 2 port (SV221MICRA/SV221MICUSBA) KVM switch
Installation
This section will guide you through the installation of your KVM with audio switch.
Please read through this section carefully and complete each step in the order listed.
Connecting Your Console
2 Port Starview Mini KVM Switch (SV221MICRA)
1. Make sure all computers that are to be connected to the KVM switch and their
peripherals are powered off.
2. Plug your VGA monitor into the blue HDB15 port on the back of the KVM switch.
3. Plug your PS/2 keyboard into the purple Mini-Din-6-port located on the front of the
KVM switch.
4. Plug your PS/2 mouse into the green Mini-Din-6-port located on the front of the
KVM switch.
5. Plug your speaker set and microphone into the colored jacks located on the front of
the KVM switch.
6. Using the built-in KVM Audio/Mic combo cables, secure the keyboard (purple),
mouse (green), and monitor(blue) connectors to the computer you want designated
as Computer 1.
7. Using the built-in KVM Audio/Mic combo cables, secure the keyboard (purple),
mouse (green), and monitor(blue) connectors to the computer you want designated
as Computer 2.
8. Power up the connected computers. Both yellow LEDs should now be lit.
Connecting Your Console
2 Port Starview USB Mini KVM Switch (SV221MICUSB)
1. Make sure all computers that are to be connected to the KVM switch and their
peripherals are powered off.
2. Plug your VGA monitor into the blue HDB15 port on the back of the KVM switch.
3. Plug your PS/2 keyboard into the purple Mini-Din-6-port located on the front of the
KVM switch.
4. Plug your PS/2 mouse into the green Mini-Din-6-port located on the front of the
KVM switch.
5. Plug your speaker set and microphone into the colored jacks located on the front of
the KVM switch.
6. Secure the USB connector to the computer you want designated as Computer 1.
7. Secure the USB connector to the computer you want designated as Computer 2.
8. Power up the connected computers. Both yellow LEDs should now be lit.
4
3
Using Your KVM Switch with Audio/Microphone
The LED on the front of the switch indicates which computer is active. You can
scroll between computers by either pressing the push-button on the front of the
switch or by using a hotkey command. A hotkey command is a short sequence of
keystrokes beginning with the Scroll Lock keystroke followed by another keystroke.
NOTE: Do not use the number pad for hotkey combinations.
Selecting a Computer
Auto-scan Mode
Auto-scan mode will be suspended if the switch detects any keyboard or mouse
activity. When the activity ceases, auto-scan will resume. The auto-scan default
setting is 5 seconds.
Command Hotkey sequence
Start auto-scan Scroll Lock + Scroll Lock + ‘S’
End auto-scan Press any key on keyboard
Command Hotkey sequence
Select computer 1 Scroll Lock + Scroll Lock + 1
Select computer 2 Scroll Lock + Scroll Lock + 2
Select the active Audio/Mic Scroll Lock + Scroll Lock + (Fx)
(Fx is a function key) and x=1~2 for Audio Mic channel number
Scroll between powered-on Scroll Lock + Scroll Lock + Up/Down arrow
computers
Console Mouse/Keyboard Scroll Lock + Scroll Lock + ‘End’
Reset
(only for PS/2 interface)
Bind the PC & Audio/Mic Scroll Lock + Scroll Lock + ‘Q’
Switching
Unbind the PC & Audio/Mic Scroll Lock + Scroll Lock + ‘W’
Switching