Instruction manual

Instruction Manual
19
The Admin functions allow you to access all of the features you will need to perform an
initial conguration of the SV1115IPEXT.
Dynamic Host Conguration Protocol (DHCP)
Automatic network conguration using DHCP is: Enabled/Disabled. This feature applies
only to the LAN port on the rear panel, and is enabled by default. When enabled,
the unit will automatically congure itself with an IP address when a DHCP server
is present. When disabled, the LAN port will use the values assigned to it on the IP
Addresses and Routing table below.
IP Addresses and Routing
This table allows you to assign IP information for the LAN and WAN ports separately. If
you are using DHCP, the values for the LAN port will be lled in automatically and any
changes made will not aect the setup. If Ethernet Bridging is enabled, the WAN port
will use the same settings as the LAN port, and any changes will not aect the setup for
that port. Adjusting the setting for the WAN port allows you greater control over how
the SV1115IPEXT is congured for access from outside the local network, particularly if
a rewall or proxy is in use.
This section allows you to specify DNS servers and the default DNS domain sux in use
on the network. If DHCP is enabled, some of these values may be supplied automatically.
Domain Name Server (optional)
This section allows you to specify DNS servers and the default DNS domain sux in use
on the network. If DHCP is enabled, some of these values may be supplied automatically.