Instruction manual

Instruction Manual

*sample HyperTerminal conguration

Terminal Conguration Using a Serial Cable

Conguring the SV1115IPEXT using a serial cable is the best choice if you need to

precongure the unit before attaching it to a network, (i.e. when sending to a branch

oce, customer site, etc). In general, the Web conguration is preferable because of

its intuitive interface and the fact that you do not have to be within close physical

proximity to perform the conguration. However, if you wish to use the serial cable

method to congure the SV1115IPEXT, you can use any typical communication

software package (UNIX: tip, cu, kermit, minicom; Windows: HyperTerminal, kermit).

You can use either serial port on the SV1115IPEXT to access the terminal conguration

tool; your choice will dictate the type of cable you will use to make the connection. The

DTE Serial port on the front panel requires the use of a null modem serial cable. The

DCE Serial port on the rear panel requires the use of a straight through serial cable.

Connect a female end of a serial cable to the serial port used for serial access on the

host computer. Connect the opposite end (male if connecting to the DCE Serial port,

female if connecting to the DTE Serial port) to the SV1115IPEXT. Congure the terminal

software with “8N1” settings:

Connection speed: 115200 bps

No. of bits: 8

Parity: None

Stop bits: 1