Owner manual
Instruction Manual
6
Computer Preliminary Setup
Find your computer’s IP address and default Gateway by doing the following:
1. Click on Start, then RUN.
2. Enter CMD in the text box.
3. Click on [OK] or press the [Enter] key.
4. When the command line window opens, Type ipcong, then press Enter:
5. Look for the heading that says Ethernet adapter Local Area Connection:
6. Write down the IP Address and Default Gateway. If the rst three
groups of numbers of your IP Address happens to be 192.168.0,
proceed to Hardware Set Up.
7. Exit the command line by clicking on the “X” on the top right corner of
the Command line window SV1107IPEXT preliminary setup