Instruction manual

Connect the Receiver to the power source using the power adapter 6.

provided.

Using the Monitor Out ports, connect the Receiver to the display. 7.

Note that each Receiver unit can be connected to two separate

displays simultaneously. To connect two monitors, simply connect a

VGA cable from the second Monitor Out to a second display.

Once the Transmitter and Receiver unit(s) have been positioned, 8.

connect the Cat5 OUT ports provided by the Transmitter unit to each

Receiver Unit, using standard UTP cable, with RJ45 connectors on

each end.

The following diagram illustrates the connection between Transmitter

and receiver units.

ST1214T/ST1218T (local), ST121EXT (extender), ST121R (Remote)

Using the Transmitter Unit, you can split the VGA signal from the

source into 4 separate VGA signals, for reception at remote locations.

While the maximum transmission distance of the Transmitter is 150m

(492ft), using the Extender Unit as a signal repeater adds another

150m (492ft) to the total transmission distance, for a total extension of

300m (984ft).

VGA cable

Cat5 cables

(150m max)

VGA cables

Video Source

Remote

Displays

ST1214T

ST121R